GSC10

Forum guidelines BT super discount
General Discussion Triathlon Talk » GSC10 Rss Feed  
Moderators: k9car363, alicefoeller Reply
2013-05-15 9:42 PM

User image

Regular
316
100100100
Subject: GSC10

Got an issue w/my GSC 10.  Popped off my bike 10 days ago during a ride.  Now I can't get it to pair up.  I get the red/green light when pressing the reset, but NOTHING after that.

 

Advice???

2013-05-16 12:26 AM
in reply to: #4744641

User image

Regular
673
5001002525
SF Bay area
Subject: RE: GSC10
Have you had the receiving device do a search for it to try and reconnect? On the 910 it is something like bike/bike settings/bike1/ant+speed\cadence, then select 'search'.
2013-05-16 4:43 AM
in reply to: #4744718

User image

Master
3486
20001000100100100100252525
Fort Wayne
Subject: RE: GSC10

TTom - 2013-05-16 1:26 AM Have you had the receiving device do a search for it to try and reconnect? On the 910 it is something like bike/bike settings/bike1/ant+speed\cadence, then select 'search'.

^^^^This

My 9120 was acting up a while ago and I was losing the cadence for most of my rides intermittently throughout entire rides.  I simply searched for the sensor (as stated above) and could connect again.

2013-05-16 9:17 AM
in reply to: #4744641


70
2525
Subject: RE: GSC10

Do you get the red and green lights when you turn the pedals/spin the wheel?  Even if it's not paired up you should still see the lights whenever the magnets pass by.  If you have the sensors close enough to the magnets but they still aren't picking them up then you might need to return it to garmin.  

I had a similar issue and sent it back and they replaced it.  They didn't promise they would replace it but once i sent it back it was messed up and they sent a new one back.

New Thread
General Discussion Triathlon Talk » GSC10 Rss Feed