I have an Elite Razor, which is one of the most praised tri-bikes around. It is made of Easton Scanium Aluminum and was custom build and painted in the USA. This is a 2003 model. A new one with ultegra components would run you about $4200, but I am willing to let it go for $1600.................................................................................................................................... WAIT....Let's mark this bad boy down to a MERE $1350!
Where will you find that kind of transition area cred for only 1350?
As far as sizing goes, this bike is well suited for somebody around 6'1"-6"3 with a short torso and longer legs.
E-mail me at
[email protected]. I take Paypal. I will include shipping in the price, or you can pick it up and I will lower the price to reflect what shipping would have cost. I am located in South Carolina and will be doing the remaining South Carolina Triathlon Series races, if you want to check it out.
Frame Measurements:
Seat tube length
(BB to top tube
): 57 CM
BB to top of collar: 68 CM
Top Tube: 51 CM
Steerer Tube: 16.5 CM
(from headset to headset
)
Standover: 81 CM
Chainstay: 42 CM
Downtube: 72.? degree
Seat tube angle: 76 or 76.5 degree
( I Failed geometry
)
Component Measurements:
Ultegra
(2003?
) Crank Length: 180 MM
ITM Millenium Stem : 90 MM
Components:
Front Derailleur: Ultegra
Rear Derailleur
(9speed
): Ultegra
Brakes: Ultegra Brakes
Headset:Chris King
Fork: Reynolds Ouzo Fork
Profile Aerolite Bars
Brake Levers: Dia Compe
Bar End Shifters: Shimano
Seatpost: Bontrager Carbon
Wheels: Bontrager Select
Tires: Michelin Pro Race 2
Saddle
(which I will keep, unless you really want it
): Blackwell Flow
Colors and cosmetic damage:
Blue and white with a slight metallic sparkle
White seat and handlebar tape
scratches on one of the seat stays, due to transportation mishap
(which I touched up
)
cable rub on the steerer tube paint