Road aero set-up, almost complete -- offers and maybe part-out

Editing the clamp diameter for the handlebars and clip-ons:

I do have a set of pads that I will include with the clip-on bars.

So I guess I'll set separate prices for the items:

Profile Design Tri-Stryke clip-ons, 31.8mm clamp, pads included but don't have the bolts to hold them onto the clamps, and no shims -- $25 shipped in CONUS.

Profile Air Wing base bar, 31.8mm clamp diameter, 42cm width -- $20 shipped in CONUS.

Tektro aero brake levers -- $15 shipped in CONUS.

Shimano 8-speed bar end shifters (including shifter boss cable stops) -- $25 shipped in CONUS.

How much are you asking for the entire setup, shpd?

How about $75 shipped for the whole thing?

Let me check with my daughter and see what she'd like to do. What type of Bull bar is it? Also, can you tell me about the shifters and brakes as well as the collar?  Thanks!!

The base bar is an "oversize" Profile Air Wing bullhorn. Uncut, never even ridden (just installed on this set-up which was a project I never completed). 42cm width, which is about the most common size. The "oversize" part is the 31.8mm stem clamp area diameter.

Shifters are Shimano 8-speed bar-ends. They didn't (and still don't as far as I know) differentiate the Dura-Ace vs Ultegra vs 105 groups for bar-end shifters. The rear shifter has a ring that can be turned that puts them into "friction" mode (which means they don't "click" into gear -- you can move it to where ever you need it), so it they can be used for 7-, 8-, 9-, or even 10-speed systems.

The brake levers are kind of a vanilla aero brake lever, made by Tektro, who also made the Cane Creek levers. Aluminum, external cable (so you don't have to fish the cable through the handlebars).

Not sure what you meant by "collar" though...

I'll take the shifters, base bar and brake levers.  PM sent.

Edited by undertheradar 2010-08-26 12:04 PM

Base bar, shifters, and brake levers are sold.

Clip-ons are still available. I do have a set of pads for them, just missing the hardware to attach the pads to the brackets.

I'll take the clip-ons. I have the same set that were cut by the previous owner and are a bit short for me. I'll send a PM as well