login
xlab nut - nanoflator/ speed chuck
-
No new posts
 2009-08-12 1:30 PM |
Expert  1023  Malvern, England |  Subject: xlab nut - nanoflator/ speed chuckI have just got a rear hydration system and and and xnut. Of course my old co2 inflator isn't threaded so I will have to change. I know I need to get threaded co2 - can I get any threaded or are xlab special size???? to go with... - nanoflator or speed chuck? Is this an either or or does the speed chuck attach to the nanoflator to control flow. If speed chuck is just a nanoflator with control doesn't this make more sense to buy compared with nanoflator? Thanks Jackie |
| 2009-08-12 1:42 PM in reply to: #2344273 |
| Subject: RE: xlab nut - nanoflator/ speed chuck Honestly, I was never very good with inflators that didn't have a lever. I hated the speed chuck. SOmeone gave me the idea to buy one of these http://www.onetri.com/genuine-innovations-proflate-inflator-p-3317.html and just remove the "holder" for the cartridge, leaving just the head. Not much bigger/heavier than the chuck and full control. Chuck kinda gives you control thru the spring, but I found it didn't work well for me |
| 2009-08-12 9:26 PM in reply to: #2344310 |
Expert 1023 Malvern, England | Subject: RE: xlab nut - nanoflator/ speed chuck thanks chrism the one I use is a lever thing because I was so rubbish at getting all the co2 in first time with no control! I am now wondering whether the one I have will actually fit if I take the cartridge covering off. Thanks for the idea. Then all I'll need to do is get some threaded cartridges. Jackie |
|
|
|
View profile
Add to friends
Go to training log
Go to race log
Send a message
View album
CONNECT WITH FACEBOOK